Device for centering and height positioning of an installation set
DE102017117541A1
adapter
DE102013101462A1
installation kit
DE102013101463A1
installation kit
DE102009056888A1
Pull-out locking device for fitting set, has inner sleeve pipe that is determined in outer sleeve pipe in sliding manner, where recess is present at contact side of inner sleeve pipe with outer sleeve pipe
DE102009017313A1
Bell mounting for installation kits and assembly procedures
DE102008011319A1
Installation fitting for e.g. drinking water pipeline, has insert made of material with higher compressive strength than plastic, and arranged in coupling sleeve, where sleeve has two closure surfaces
DE102008011318A1
Assembly fixture has fixture actuating linkage and dome sleeve with material which has fiber reinforced plastic, where dome sleeve contains body with rotational axis and two closing surfaces that are perpendicular to axis of body
DE102007053928A1
Protective sleeve for installation trims
DE102007044150A1
Lift wrench for telescopic installation fittings, has bracket support axially displayed at wrench shaft, where bracket support is retractable arranged with lower end of support at wrench shaft
DE102007021161A1
Connection of actuating rod and valve spindle with the coupling sleeve for installation kits
DE102007015108A1
Wrench bar and coupling sleeve connection for e.g. telescopically adjustable installation fitting, has resting units pressed, such that pin is projected into hole of sleeve, where connection is centrally arranged in area of components
DE102007007221A1
Sleeve-type casing pipe for e.g. telescopic built-in fitting, has outer pipe jacket made of fixed and corrosion-resistant material and inner pipe jacket made of corrosion-resistant material, where jackets are connected with each other
DE102006047462B3
Distance clamp for fixture fitting, has flanks bending around quadratic middle part at specific angle of degrees, and clamp flexibly clamped between upper linkage end of fixture fitting and interior square ends of square ended schooner
DE102006019541A1
Locking clamp for telescopic installation fittings e.g. for actuating water hose valves, has spigot with flexible plate fixed on upper end
DE102006000669B3
Installation set, e.g. for operating slide valves in buried gas/water pipes, has a locking pin through the inserted components of the operating rod with a magnet head at the pin shaft
DE102005042447A1
Assembly fitting with armature actuating rod assembly and cylindrical coupling sleeve made of fiber-reinforced polyamide and with inner recesses, to couple armature to rod assembly
DE102004061168A1
Built in fitting has pipe sleeve to protect and guide actuating rods of domestic armature fixings on underfloor piping with removeable cover flap at pipe sleeve opening made of positionable matieral or with positionable part
DE10320426A1
Heading for sturdy and durable installation of telescopic system in ground, has cladding tube cap that is fixed to sealing cap and abuts key bar pallet